Blast chiller tunnel
| Cell | |
|---|---|
| Tunnel body | Made of 304 stainless steel for greater rigidity at low temperatures, no rust or toxic particles generated by flaking, and full compliance with food hygiene regulations |
| Trolleys | 3 |
| Internal volume m³ | m³ |
| Evaporator | |
|---|---|
| Heat exchanger | With anti-corrosion treatment, generously sized, constructed with stainless steel pipes. |
| Defrosting | Stainless steel electric heating elements with vulcanized terminals |
| Expansion valve | Electronic, including driver and graphic display integrated into the electrical panel |
| Solenoid valve | Direct acting, normally closed and operated by a coil suitable for continuous operation |
| Fans | 3 |
| Fan diameter | 630 mmØ |
| Total air flow | 36000 m³h |
| Door front panel |
|---|
| Touch screen for parameter settings |
| General alarm signal |
| Cell light switch |
| System on/off switch |
| Trolley | |
|---|---|
| Voltage | 400V/3/50Hz |
| Nominal current | – |
| Nominal power | – |
| Code | 111102410 |
K360 BTDST special double-stage inverter outdoor condensing unit
| Technical description | |
|---|---|
| Load-bearing body | Body made of galvanized steel sheet and aluminum, with epoxy powder coating for protection against atmospheric agents. The paneling is easily removable for easy maintenance of the internal parts. |
| Compressor | Semi-hermetic two-stage compressor complete with rubber shock absorbers, thermistors for electrical protection of the motor, oil differential pressure switch, suction valve, compression valve, and crankcase heater. |
| Subcooler | Steel plate subcooler complete with expansion valve, filter, liquid sight glass, and solenoid valve. |
| Condenser | Consisting of a large air heat exchanger made of copper pipes and aluminum fins, equipped with an air conveyor to increase performance and heat exchange efficiency, complete with motorized fans with painted metal grille and high-efficiency profile blades. |
| Condensation control | Condensation is regulated automatically and controlled by a pressure sensor to ensure condensation as the ambient temperature chang |
| Accessories | • Painted steel liquid receiver with dip tube, complete with inlet and outlet valves and safety valve • Dehydrator filter • Liquid and humidity indicator • High pressure switch • Low pressure switch • Refrigeration circuit made with copper pipe suitable for refrigeration, certified according to EN 12735-2 |
| Electrical panel | • Fan speed control devices • Dedicated software for controlling and monitoring compressors, alarms, set values, and calculating electricity consumption. • Provision for remote management |
| Model | K360 BTDST |
| Output* | 25300 W |
| Power consumption | 20640 |
| Voltage | 400V/3/50Hz |
| Nominal current | – |
| Nominal power | – |
| Refrigerant type | R507A |
| Compressor type | SDI |
| Fin pitch | 2,1 mm |
| Fans | 3 x Ø560 |
| Nominal power consumption | – |
| Air flow rate | – |
| Net weight | 1000 |
| Code | 111103667 |
*-40°C / +40°C
